Table of Contents
Advertisement
3.8 Flats on shafts
Fig. 24: Flats on shafts
(1) - Flat
Some shafts have flat surfaces at the points where the components are
screwed on. This stabilizes the connection and makes adjusting easier.
Important
Always ensure that the screws are completely flush with the surface.
The rule is to always place the 1
the flat.
34
NOTICE
Property damage may occur!
An incorrect setting can result in damage to the machine.
Always place the first screw in rotational direction onto the flat.
①
②
(2) - Shaft
st
screw in rotational direction onto
Service Instructions D868 M-TYPE DELTA - 00.0 - 06/2020
Working basis
Advertisement
Table of Contents
