Table of Contents
Advertisement
7.3 Aligning the needle bar linkage in the sewing direction
Fig. 38: Aligning the needle bar linkage in the sewing direction
(1) - Screw
Proper setting
If the stitch length is 0, the needle pierces exactly in the center of the
needle hole.
To align the needle bar linkage in the sewing direction:
1. Switch off the machine.
2. Disassemble the front cover ( p. 20).
3. Switch on the machine.
4. Execute the service routine Needle-Hook > Needle bar ( p. 14).
The software is used to define the necessary presettings on the
5. Loosen the screw (1).
6. Move the needle bar linkage until there is a distance of 10 mm
7. Tighten the screw (1).
8. Finish the service routine.
50
10 mm
machine.
between presser bar and walking foot bar.
Adjusting feed dog and needle bar linkage
Service Instructions D868 M-TYPE DELTA - 00.0 - 06/2020
①
Advertisement
Table of Contents
