Table of Contents
Advertisement
Safety
2
This chapter contains basic information for your safety. Read the instruc-
tions carefully before setting up or operating the machine. Failure to do so
can result in serious injury and property damage.
2.1 Basic safety instructions
The machine may only be used as described in these instructions.
These instructions must be available at the machine's location at all times.
Work on live components and equipment is prohibited. Exceptions are
defined in the DIN VDE 0105.
For the following work, switch off the machine at the main switch or
disconnect the power plug:
Missing or faulty parts could impair safety and damage the machine.
Only use original parts from the manufacturer.
Use a lifting carriage or stacker to transport the machine. Raise the machine
Transport
max. 20 mm and secure it to prevent it from slipping off.
The connecting cable must have a power plug approved in the relevant
Setup
country. The power plug may only be assembled to the power cable by
qualified specialists.
Follow the country-specific safety and accident prevention regulations and
Obligations
of the operator
the legal regulations concerning industrial safety and the protection of the
environment.
All the warnings and safety signs on the machine must always be in legible
condition. Do not remove!
Missing or damaged warnings and safety signs must be replaced
immediately.
Only qualified specialists may be used for:
Requirements
to be met by
the personnel
Only authorized persons may work on the machine and must first have
understood these instructions.
Service Instructions D868 M-TYPE DELTA - 00.0 - 06/2020
Safety
• Replacing the needle or other sewing tools
• Leaving the workstation
• Performing maintenance work and repairs
• Threading
• Setting up the machine/putting the machine into operation
• Performing maintenance work and repairs
• Performing work on electrical equipment
9
Advertisement
Table of Contents
