DURKOPP ADLER D868 Service Instructions Manual page 58

To adjust the hook side clearance:
1. Execute the service routine Needle-Hook > Timing ( p. 14).
 The software is used to define the necessary presettings on
2. Lock the machine in place ( p. 35).
3. Open the hook cover ( p. 28).
4. Tilt the machine head ( p. 18).
5. Loosen the screws (4).
6. Loosen the threaded pin (2).
7. Move the hook support (3) sideways such that the distance between
Information
You can slightly loosen the threaded pins (1) if the hook support can only
be moved with difficulty.
8. Tighten the threaded pin (2).
9. Tighten the screws (4).
10. Finish the service routine.
Order
Then, check the following setting:
56
the machine.
the hook tip and the groove of the needle is no greater than 0.1 mm.
• Position of the needle guard ( p. 57)
Position of the hook and needle
Service Instructions D868 M-TYPE DELTA - 00.0 - 06/2020