Table of Contents
Advertisement
5.2 Adjusting the compensating weight
Proper setting
The screw of the compensating weight is level with the1
rotational direction of the eccentric that is used for the feed dog movement.
The compensating weight does not collide with the transmission lever on the
side.
Fig. 32: Adjusting the compensating weight
(1) - Screw
(2) - Compensating weight
To adjust the compensating weight:
1. Loosen the screw (1).
2. Adjust the compensating weight (2) such that screw (1) and screw (4)
3. Tighten the screw (1).
42
①
②
are at the same height.
Make sure there is a gap between the compensating weight (2) and
the transmission lever (3).
Performing the basic settings of the eccentrics
(3) - Transmission lever
(4) - Screw
Service Instructions D868 M-TYPE DELTA - 00.0 - 06/2020
st
screw in the
④
③
Advertisement
Table of Contents
