DURKOPP ADLER D868 Service Instructions Manual page 202

Code
1004
1005
1006
1007
1008
1010
1011
1012
1054
1055
1060
1061
200
Type Meaning
Error Incorrect sewing motor
direction of rotation
Error Motor blocked
Error Maximum speed exceeded
Error Error in the reference run
Error Sewing motor encoder error
Error External synchronizer plug
(Sub-D, 9-pin) not connected
Error Encoder Z pulse missing
Error Synchronizer fault
Error Internal short circuit
Error Sewing motor overload
Error Sewing motor overload /
overvoltage /overcurrent
Error Sewing motor overload /
overvoltage /overcurrent
Service Instructions D868 M-TYPE DELTA - 00.0 - 06/2020
Troubleshooting
Remedial action
• Replace encoder
• Check motor plug
assignment and change it
if necessary
• Check wiring in machine
distributor and change it, if
necessary
• Test motor phases and
check for correct value
• Check for stiff movement
• Replace encoder
• Replace sewing motor
• Replace encoder
• Perform reset
• Check class (t 51 04)
• Replace encoder
• Check for stiff movement
• Replace encoder
• Connect cable of external
synchronizer to control,
make sure that interface
(Sync) is correct
• Only recommended for
machines with
transmission!
• Switch off the control, use
handwheel to turn, and
switch on the control
again
• If error is not corrected,
check encoder
• Replace synchronizer
• Replace control
• Check for stiff movement
• Replace encoder
• Replace sewing motor
• Check selection of class
• Replace control
• Replace motor
• Replace encoder
• Check selection of class
• Replace control
• Replace motor
• Replace encoder