Connecting the N-560 to AC Power
Connecting a Sensor to the N-560
N-560 Operator's Manual
1. Plug the female connector of the power cord into the N-560
AC power connector (1).
2. Plug the male connector of the power cord into a properly grounded
AC outlet.
3. Verify that the
AC Power
WARNING: Use only the DOC-10 pulse oximetry cable with the
N-560. Use of another sensor cable will have an adverse effect on
performance. Do not attach any cable that is intended for computer
use to the sensor port. Do not connect any device other than a
Nellcor-approved sensor to the sensor connector.
1. Power Connector
Indicator is lit.
Setting up the N-560
17