Teledyne 400E Instruction Manual page 59

Model 400E Ozone Analyzer
Instruction Manual
Parameter
O3GENDRIVE
SAMPPRESS
SAMPFLOW
SAMPTEMP
PHOTOLTEMP
O3SCRUBTEM
P
O3GENTEMP
BOXTEMP
SLOPE
OFFSET
TESTCHAN
CLOCKTIME
(1)
Only appears if IZS option is installed.
(2)
Only appears if IZS Reference Sensor option is installed.
(3)
Only appears if Metal Wool Scrubber option is installed.
(4)
Only appears if Analog Output A4 is activ ely reporting a Test Function.
P/N 04316 Rev: B
Table 6-2: Test Functions Defined (continued)
Display Title Units
(1)
O3 DRIVE
PRES
In-Hg-A
SAMP FL cc/min
SAMPLE TEMP
PHOTO LAMP
(3)
O3 SCRUB
(1)
O3 GEN TMP
BOX TEMP
SLOPE
OFFSET
(4)
TEST
TIME HH:MM:SS
mV
The Drive voltage used to control the intensity of
the O generator UV Lamp.
3
The absolute pressure of the Sample Gas as
measured by a solid state pressure sensor.
Sample Gas mass flow rate as measured by the
Flow Sensor located between the Optical Bench
and the Sample Pump.
°C
The Temperature of the gas inside the Sample
Chamber.
°C
The Temperature of the UV Lamp in the Optical
Bench.
°C
The current temperature of the Metal Wool
(3)
Scrubber.
°C
The Temperature of the UV Lamp in the O
(1)
Generator.
°C The temperature inside the analyzer chassis.
- -
The Slope of the instrument as calculated during
the last calibration activity.
When the unit is set for SINGLE or DUAL Range
mode, this is the SLOPE of RANGE1.
When the unit is set for AUTO Range mode, this
is the SLOPE of the current range.
PPB
The Offset of the instrument as calculated during
the last calibration activity.
When the unit is set for SINGLE or DUAL Range
mode, this is the OFFSET of RANGE1.
mV
Displays the signal level of whatever Test
function is currently being output by the Analog
Output Channel A4.
The current time. This is used to create a time
stamp on iDAS readings, and by the AutoCal
feature to trigger calibration events.
Operating Instructions
Meaning
(1)
3
(4)
59