Teledyne 400E Instruction Manual page 40

Getting Started
2. Set the expected O3 span gas concentration:
SAMPLE
< TST TST > CAL
M-P CAL
< TST TST > ZERO
M-P CAL
SPAN
M-P CAL
4
0 0
For this Initial Calibration it is important to independently verify
the PRECISE O
40
RANGE = 500.0 PPB
RANGE = 500.0 PPB
CONC
RANGE = 500.0 PPB
400.0 Conc
03 SPAN CONC:
0 0 .0 ENTR EXIT
EXIT ignores the new setting and returns to the previous
menu.
ENTR accepts the new setting and returns to the
previous menu.
Concentratio n Value of the SPAN gas.
3
O3 =
SETUP This sequence causes the
analyzer to prompt for the
expected O
concentration.
O3 =
EXIT
O3 =
EXIT
The O
3
Make sure that you input the ACTUAL
concentration value of the SPAN Gas.
To change this value to meet the actual
concentration of the SPAN Gas, enter the
number sequence by pressing the key under
each digit until the expected value is set.
NOTE
Model 400E Ozone Analyzer
Instruction Manual
span
3
span concentration value automatically
defaults to 400.0 Conc .
P/N 04316 Rev: B