To Remove And Replace The Probe Power And Control Assembly - Agilent Technologies 54845B Manual

Chapter 6: Replacing Assemblies

To remove and replace the probe power and control assembly

To remove and replace the probe power and control assembly

Use this procedure to remove the probe power and control assembly. When necessary, refer to
other removal procedures.
Figure 6-8
Probe Power and Control Assembly
Disconnect the power cable and remove the cover.
1
Disconnect the mylar flex cable W8 that connects the probe power and control
2
assembly to the AutoProbe assembly.
The connector must be unlocked before you can remove the flex cable. See "To disconnect and
connect Mylar flex cables" in this chapter.
Disconnect the mylar flex cable W17 from the probe power and control assembly.
3
Remove the two Torx T10 screws securing the probe power and control assembly to
4
the chassis.
Avoid Interference with the Fan
You may need to use a Torx key or stubby Torx driver to avoid interference with the fan.
6–8