....................................................................................................................................................................................................................................

Overview

Before you begin

Installation procedure

3 - 1 6

The rack adapter kit is used to mount rack frames together

side-by-side to establish a line-up.

If the existing rack(s) already have side-cover plates, remove these

cover plates from the sides of the existing rack(s) to which another

rack(s) will be connected. See

instructions on how to re-install side-cover plates.

............................................................................................................................................................

Extension side of the

existing rack is

At the front to the left

At the front to the right

............................................................................................................................................................

Remove the Assy, Cage Nut — DC1002834 on the opposite side to

the demounted rack adapter-kit (see Step 1) (two at the top and the

two at the bottom).

............................................................................................................................................................

Place the rack frame (item 4) of the extension rack next to the

existing rack.

............................................................................................................................................................

Put the bushings (= spacers) for adapter kit — CC848316279 (item 1)

in the rack frame and fix them by using CH SCR, STL ST-70, M4x25

screws — CC847117900 (item 2) and STL, ST-70-140HV, 4.3x12

washers — CC847174950 (item 3) at each nut retainer-position.

............................................................................................................................................................

Tighten the CH SCR, STL ST-70, M4x25 screws — CC847117900

(item 2) to tie the rack frames together.

N D

O F

T E P S

............................................................................................................................................................

Lucent Technologies

"Side cover plates" (4-71)

Then

Demount the rack adapter-kit on the

extension rack.

Demount the rack adapter-kit on the

existing rack.

Mechanical installation

for

365-374-074

Issue a, April 2002

Table of Contents