....................................................................................................................................................................................................................................

Before you begin

Installation procedure

365-374-074

Issue a, April 2002

The side cover plates can be mounted on each side of a stand-alone

rack frame, but within a rack line-up the two outer sides of the

cabinet can be covered only.

............................................................................................................................................................

Check that the cage nuts — DC1002834 (item 3) are mounted in the

designated gaps in the rack frame.

............................................................................................................................................................

Attach the side cover plates (item 1) to the rack frame by using

screws (item 2). The following side cover plates should be used:

•

CC848780177 in case of an ETSI-2 rack.

•

CC848780185 in case of an NEBS-2000 rack

NOTE: The mentioned comcodes represent always a pair of side

cover plates (left and right).

N D

O F

T E P S

............................................................................................................................................................

Lucent Technologies

System cabling and final assembly

4 - 7 1

Table of Contents