....................................................................................................................................................................................................................................

Positioning

365-374-074

Issue a, April 2002

............................................................................................................................................................

Place the lower hinge-pin of the door into the eye of the Door

Support Bottom. The following rack doors should be used:

•

CC848795001 in case of an ETSI-2 rack.

•

CC848795019 in case of an NEBS-2000 rack

NOTE: The mentioned comcodes represent always a pair of rack

doors (left and right).

............................................................................................................................................................

Pull down the locking mechanism at the top of the door.

............................................................................................................................................................

Lock the door by releasing the locking mechanism of the upper

hinge-pin in the eye of the Door Support Top.

..........................................................................................................................................................

In the case of ...

an ETSI-2 rack

an NEBS-2000 rack

N D

O F

T E P S

............................................................................................................................................................

Lucent Technologies

System cabling and final assembly

Then ...

no grounding is needed between doors

and rack frame.

connect the Ground Strips —

DC1005100 (item 1) at the top and

bottom of each rack door.

4 - 7 3

Table of Contents