....................................................................................................................................................................................................................................

Overview

Procedure

365-374-074

Issue a, April 2002

The procedure described below should be performed if no remote

Follow the steps below in the case of a remote login failure:

............................................................................................................................................................

Check that the DCC channels are configured correctly (see Chapter 8,

section

"Provision DCC"

IF ...

a remote login is not

possible,

a remote login is possible,

..........................................................................................................................................................

Reset the CTL circuit pack of the near-end NE. To do this, open the

latches simultaneously and wait until the red LED is illuminating

continously. Then pull and move back the controller.

IF ...

a remote login is not

possible,

a remote login is possible,

..........................................................................................................................................................

Reset the CTL circuit pack of the far-end NE.

IF ...

a remote login is not

possible,

a remote login is possible,

..........................................................................................................................................................

Perform a reload of the NE software to the CompactFlash card of the

near-end NE (see

Lucent Technologies

(8-10)).

THEN ...

proceed to step 2.

END OF STEPS

THEN ...

proceed to step 3.

END OF STEPS

THEN ...

proceed to step 4.