Table of Contents
Advertisement
DCM cabling
....................................................................................................................................................................................................................................
Routing
....................................................................................................................................................................................................................................
E - 4
Important! Only the fiber cables with listed comcodes are to be used,
Cables
otherwise the proper functioning of the system can not be guaranteed.
The
"Single Mode 9/125 fiber-optic cables" (C-2)
DCF modules, which should have an LC connector with a 45° boot.
The cables can be routed from both sides of the rack to the front of
the unit (see next figure).
Figure E-3 Cable routing for the DCM Carrier
Lucent Technologies
DCM (OEM equipment)
are used for the
365-374-074
Issue a, April 2002
Advertisement
Table of Contents
