Install Ip Daughterboards; Software Enable The Dti/Pri Cards; Software Enable The Ntrb21 Tmdi Card; Software Enable The Ntak09 Card - Nortel Meridian 1 Option 11C Manual

Page 26 of 100 PRI Implementation

Install IP daughterboards

Software enable the DTI/PRI cards

Software enable the NTRB21 TMDI card

Software enable the NTAK09 card

553-3011-310 Standard 13.00
Refer to Option 11C Planning and Installation (553-3021-210).
1 Enable the NTRB21 TMDI card using the following overlay and
command:
LD 96 ENL TMDI x
where x is the NTRB21 TMDI card number (DLOP). The card number
associated with a NTRB21 TMDI card is based on the slot in which the
card is installed (1-49).
2 If in PRI mode, S/W enable the associated D-channel using the following
overlay and commands:
LD 96 ENL DCH y
Where y is the DCH port number that was assigned in LD 17.
Within about 30 seconds, the D-channel layer 3 should be established. To
confirm, request the current status of the D-channel by using the LD 60
command STAT DCH (N).
The system should respond DCH N EST OPER, meaning that the D-channel
is established and operational.
Use step 1 to enable NTAK09 DTI/PRI card. If the clock controller and
D-channel interface are not enabled in step 1, go to step 2.
Step 1
• Software enable all NTAK09 DTI/PRI cards using LD 60:
ENLL C
Where C is the DTI/PRI card number (DLOP). The card number
associated with a DTI/PRI card is based on the slot in which the card is
installed.
January 2002