Completion Of Program Creation And Saving Programs - Mitsubishi MELFA CR1D Instruction Manual

(3) Completion of program creation and saving programs

If the function key which corresponds for "closing" is pressed, the program will be saved and creation will be
finished.
If the "close" is not indicated, press the [FUNCTION] key, and display it.
<PROGRAM> 1
1 Mov P1
2 Mov P2
3 End
CHANGE
DIRECT
Save & exit of the program [F4]
◇◆◇ Precautions when saving programs ◇◆◇
Make sure to perform the operation above. The edited data will not be updated if the power is turned off
without doing so after modifying a program on the program edit screen. Moreover, as much as possible, try
to save programs not only on the controller but also on a PC in order to make backup copies of your
work.It is recommended to manage programs using RT ToolBox 2 (optional).
50%
⇒
123 CLOSE
3Explanation of operation methods
<FILE/EDIT> 1/20
1 08-04-24 17:20:32
2 08-04-24 14:56:08
A1 08-04-24 13:05:54
B1 08-04-24 13:05:54
123 NEW
EDIT POSI.
Rem 136320
22490
694
2208
1851
⇒
COPY
Programming 3-32