Mitsubishi MELFA CR1D Instruction Manual page 401

[2] Execute a restore operation by manipulating the operation panel
Power ON at
norm al operation
Power ON
STATUS NUMBER
Approx. 8 sec.
STATUS NUMBER
Approx. 12 sec.
STATUS NUMBER
[3] Change the parameter value and switch to the RAM operation.
<PARAMETER>
DATA
(1
Prev
DATA
123
<PARAMETER> NAME(ROMDRV
DATA
(0
Prev
DATA
123
Power ON after a write
restoring into the ROM area
Power ON
STATUS NUMBER
STATUS NUMBER
START
STATUS NUMBER
STATUS NUMBER
NAME(ROMDRV )
ELE( )
)
Next
CLOSE
)
ELE( )
)
Next CLOSE
The com pletion of restoring into the RAM area
is displayed.
This display varies depending on whether or
not there is extension m em ory.
OK4: W hen standard m em ory is used
OK7: W hen 2 MB extension m em ory is used
* The tim e required to start up after the power
is turned on is alm ost the sam e as the norm al
operation, which is different from when writing
Approx. 8 sec.
to the ROM area.
Press the [START] button on the operation panel.
"88888" is displayed in STATUS NUMBER just like
for norm al operation.
Approx. 12 sec.
Change the value of the ROMDRV parameter from 1 to 0.
After changing it, be sure to shut off the power, and turn it on
again.
About ROM operation/high-speed RAM operation function 5-388
5Functions set with parameters