Table of Contents
Advertisement
5Functions set with parameters
[2] Execute a copy operation by manipulating the operation panel.
Power ON at
norm al operation
Power
ON
STATUS NUMBER
Approx. 8 sec.
STATUS NUMBER
Approx. 12 sec.
STATUS NUMBER
Caution
[3] Change the parameter value and switch to the ROM operation.
<PARAMETER>
DATA
(0
Prev
DATA
<PARAMETER>
DATA
(1
Prev
DATA
5-385 About ROM operation/high-speed RAM operation function
Power ON after a write
operation into the ROM area
Power
ON
STATUS NUMBER
STATUS NUMBER
START
STATUS NUMBER
STATUS NUMBER
If switching from the RAM operation to the ROM operation is performed without
copying any program into the ROM area, there would be no program to execute, or
a program in which the corrected content has not been reflected would be executed.
Therefore, be sure to perform the program copy operation described above.
NAME(ROMDRV
)
ELE( )
)
Next
CLOSE
123
NAME(ROMDRV
)
ELE( )
)
Next
CLOSE
123
The com pletion of writing into the ROM area is
displayed.
This display varies depending on whether or
not there is extension m em ory.
OK0: W hen standard m em ory is used
OK3: W hen 2 MB extension m em ory is used
W hen 2 MB extension m em ory is used, it takes
Approx. 22 sec.
approxim ately 28 seconds longer to start up
after the power is turned on.
Press the [START] button on the operation panel.
"88888" is displayed in STATUS NUMBER just like
for norm al operation.
Approx. 12 sec.
Change the value of the ROMDRV parameter from 0 to 1.
After changing it, be sure to shut off the power, and turn it on
again.
Advertisement
Table of Contents
