Hcoe Upper Interface Cable Removal; Hcoe Latch Removal - Lexmark M52 Series Service Manual

HCOE upper interface cable removal

1
Remove the HCOE sensor cover. See
2
Remove the HCOE left cover. See
3
Disconnect the upper interface cable from the controller board.
4
Crimp both connector pins using pliers to make them fit through the pin holes. Push the connector out of
its slot.
5
Remove the upper interface cable.

HCOE latch removal

1
Remove the HCOE left cover or HCOE right cover. See
right cover removal" on page
2
Pull the latches off the expander, and then remove.
Note: The latch on the opposite side can be removed using the same method shown.
"HCOE sensor cover removal" on page
"HCOE left cover removal" on page
"HCOE left cover removal" on page 550
549.
Parts removal
554
547.
550.
4064
or "HCOE