Sensor (Staple Finisher Pass-Through) Early- Or Late-Arriving Jam Service Check - Lexmark M52 Series Service Manual

Action
Step 11
Reinstall or replace the door. See
removal" on page 582.
Does the problem remain?
Step 12
Make sure that the controller board of the affected optional bin is
properly installed. Reseat all the cables on the controller board.
Does the problem remain?
Step 13
Check the affected controller board and its connector pins for
damage.
Are the bin controller board and its connectors free of damage?
Step 14
Replace the bin controller board. See
board removal" on page
Does the problem remain?
Sensor (staple finisher pass‑through) early‑ or late‑arriving jam service check
Action
Step 1
Make sure that all the optional bins are properly installed.
Does the problem remain?
Step 2
Open all optional bin doors, and then check the paper path and
bins for paper fragments and partially fed paper.
Is the paper path free of paper fragments and partially fed paper?
Step 3
Remove the paper fragments and partially fed paper.
Does the problem remain?
Step 4
Clear the optional bin paper path rollers of any dirt and
contamination.
Does the problem remain?
"Staple finisher rear door
"Staple finisher controller
590.
Diagnostics and troubleshooting
Yes
Go to step 12.
Go to step 13.
Contact the next
level of support.
Contact the next
level of support.
Yes
Go to step 2.
Go to step 4.
Go to step 4.
Go to step 5.
222
4064
No
The problem is
solved.
The problem is
solved.
Go to step 14.
The problem is
solved.
No
The problem is
solved.
Go to step 3.
The problem is
solved.
The problem is
solved.