Sensor (Oe Pass-Through) Removal - Lexmark M52 Series Service Manual

5
Remove the six screws (B), to release the right inner frame.
6
Move away the left and right inner frames, and then pull away the bin.
Sensor (OE pass‑through) removal
1
Remove the output expander left cover. See
2
Remove the output expander right cover. See
3
Remove the output expander bin. See
4
Disconnect the sensor cable J3 from the controller board.
"Output expander left cover removal" on page
"Output expander right cover removal" on page
"Output expander bin removal" on page
Parts removal
542
4064
522.
520.
541.