Lexmark M52 Series Service Manual page 241

Action
Step 10
a
Remove the staple finisher top cover. See
cover removal" on page
b
Remove the staple finisher left cover. See
cover removal" on page
c
Reseat the cable on the motor (staple finisher right tamper) and
on the staple finisher controller board.
Does the problem remain?
Step 11
Check the motor (staple finisher right tamper) for improper
installation and damage.
Is the motor properly installed and free of damage?
Step 12
Reinstall or replace the motor. See
tamper) removal" on page
Does the problem remain?
Step 13
Check the tamper drive belt for improper installation, wear, and
damage.
Is the drive belt properly installed and free of wear and damage?
Step 14
Reinstall or replace the drive belt. See
removal" on page 620.
Does the problem remain?
Step 15
Check the tamper aligner for improper installation and damage.
Is the tamper aligner properly installed and free of damage?
Step 16
Reinstall or replace the tamper aligner. See
removal" on page 627.
Does the problem remain?
Step 17
Check the tamper gear for improper installation and damage.
Is the gear properly installed and free of damage?
"Staple finisher top
588.
"Staple finisher left
584.
"Motor (staple finisher left
619.
"Tamper drive belt
"Tamper aligner
Diagnostics and troubleshooting
241
Yes No
Go to step 11. The problem is
solved.
Go to step 13. Go to step 12.
Go to step 13. The problem is
solved.
Go to step 15. Go to step 14.
Go to step 15. The problem is
solved.
Go to step 17. Go to step 16.
Go to step 17. The problem is
solved.
Go to step 19. Go to step 18.
4064