Sensor (Mailbox Pass-Through 2) Static Jam Service Check - Lexmark M52 Series Service Manual

Sensor (mailbox pass‑through 2) static jam service check
Action
Step 1
Make sure that all the optional bins are properly installed.
Does the problem remain?
Step 2
Open all optional bin doors, and then check the paper path and
bins for paper fragments and partially fed paper.
Is the paper path free of paper fragments and partially fed paper?
Step 3
Remove the paper fragments and partially fed paper.
Does the problem remain?
Step 4
Clear the optional bin paper path rollers of any dirt and
contamination.
Does the problem remain?
Step 5
a
Enter the Diagnostics menu, and then navigate to:
Output bin quick feed > Feed to all bins
b
Touch Single or Continuous.
Does the problem remain?
Step 6
a
Enter the Diagnostics menu, and then navigate to:
Output device adjustments/tests > Output device sensor
tests > Mailbox [x]
Note: [x] is the number of the affected bin.
b
Find the sensor (Pass-through).
Does the sensor status change while toggling the sensor?
Step 7
a
Remove the mailbox left cover. See
removal" on page
b
Reseat the cable of the sensor (mailbox pass‑through 2) on the
mailbox controller board.
Does the problem remain?
"Mailbox left cover
654.
Diagnostics and troubleshooting
Yes
Go to step 2.
Go to step 4.
Go to step 4.
Go to step 5.
Go to step 6.
Go to step 10.
Go to step 8.
214
4064
No
The problem is
solved.
Go to step 3.
The problem is
solved.
The problem is
solved.
The problem is
solved.
Go to step 7.
The problem is
solved.