Sensor (Toner Density) Removal - Lexmark M52 Series Service Manual

Sensor (toner density) removal

1
Open the front door, and then remove the toner cartridge and imaging unit.
2
Remove the duplex/MPF tray. See
3
Remove the inner guide deflector. See
4
Loosen the two aligner screws (A) to allow space for the sensor removal.
5
Remove the screw (B), and then disconnect the sensor cable (C).
6
Remove the sensor.
Installation note: Make sure that the aligner screws are properly screwed back.
"Duplex/MPF tray removal" on page
"Inner guide deflector removal" on page
Parts removal
448
434.
438.
4064