Sensor (Tray 1 Pass-Through) Late-Leaving Or Did-Not-Clear Jam Service Check - Lexmark M52 Series Service Manual

Sensor (tray 1 pass‑through) late-leaving or did-not-clear jam service check
Action
Step 1
Pull out all the source trays, and then check if the paper size
matches the size set on the tray guides.
Does the paper size match the size set on the tray?
Step 2
Change the paper size or adjust the size setting in the tray.
Does the problem remain?
Step 3
Check if the tray is overfilled.
Is the tray overfilled?
Step 4
Remove the excess paper from the tray.
Does the problem remain?
Step 5
Check the tray for crumpled, damaged, or deformed paper.
Are the sheets of paper on the tray still in good condition?
Step 6
Replace the affected sheets.
Does the problem remain?
Step 7
Check the pick roller of the source tray for dirt, excess wear, and
contamination.
Note: Check also the gears for debris and toner.
Are the pick roller components free of dirt, excess wear, and
contamination?
Step 8
Clean or replace the pick roller.
Does the problem remain?
Step 9
Check the aligner rollers for obstructions.
Are the aligner rollers free of obstructions?
Diagnostics and troubleshooting
129
Yes No
Go to step 3. Go to step 2.
Go to step 3. The problem is
solved.
Go to step 4. Go to step 5.
Go to step 5. The problem is
solved.
Go to step 7. Go to step 6.
Go to step 7. The problem is
solved.
Go to step 9. Go to step 8.
Go to step 9. The problem is
solved.
Go to step 11. Go to step 10.
4064