Scheduled Maintenance; Fuser Maintenance Kits - Lexmark M52 Series Service Manual

PART/ITEM
Pick tires
MS82x Inspection guide table
PART/ITEM
Tray insert
•
Width paper guide
•
Length paper guide
Separator pad
Tray pick roller
MPF pick roller
Rear door
Duplex paper path
Toner spillage
Pick tires

Scheduled maintenance

Fuser maintenance kits

The printer may stop printing when the fuser rated life is reached. At rated fuser life, a Fuser maintenance kit
is required. The correct Fuser maintenance kit must be installed for the type of fuser that is installed in the
printer. See "Identifying the type of fuser used in the printer" on page
Code levels prior to Base code of LW20.DN4.P231-0 and Engine code of FDN.DN.E410-0 set the 80.3x error
as a non‑continuable stop. To change the 80.3x error code to a continuable stop, please see technical bulletin
TE523 by visiting www.lexmark.com. A continuable stop is an error code that will allow the user to continue
using the printer once the error is acknowledged using the control panel.
There are multiple warnings to indicate that the fuser is nearing end of life and that a maintenance kit is required.
EVERY SERVICE EVERY 200K
CALL
Inspect, clean if Inspect, clean if
needed needed
EVERY SERVICE EVERY 225K
CALL
Inspect Replace
Inspect, clean if Replace
needed
Inspect, clean Replace
Inspect, clean Inspect, clean
Inspect Inspect
Inspect Inspect
Clean Clean
Inspect, clean if Inspect, clean if
needed needed
Maintenance
758
NOTES
Check for toner
contamination.
NOTES
Check for correct
positioning.
Clean with a damp
cloth.
Clean with a damp
cloth.
Clean with a damp
cloth.
Ensure correct
operation and closure.
Check for paper
fragments and
obstructions.
Remove all toner
spillage from the
printer.
Check for toner
contamination.
762.
4064