Display Flowchart; Keypad Operation - Delta Electronics ASDA-A Series User Manual

Call 1(800)985-6929 for Sales
4.2

Display Flowchart

Figure 4.2
Monitor Mode
Monitor S tatus
or
1. When the power is applied to the AC servo drive, the LCD display will show the monitor function
codes for approximately one second, then enter into the monitor mode.
2. In monitor mode, pressing UP or DOWN arrow key can switch monitor parameter code. At this time,
monitor display symbol will display for approximately one second.
3. In monitor mode, pressing MODE key can enter into parameter mode, pressing the SHIFT key can
switch parameter group and pressing UP or DOWN arrow key can change parameter group code.
4. In parameter mode, the system will enter into the setting mode immediately after the Set key is
pressed. The LCD display will display the corresponding setting value of this parameter
simultaneously. Then, users can use UP or DOWN arrow key to change parameter value or press
Mode to exit and return back to the parameter mode.
5. In parameter setting mode, the users can move the cursor to left by pressing the SHIFT key and
change the parameter settings (blinking digits) by pressing the UP or DOWN arrow key.
6. After the setting value change is completed, press SET key to save parameter settings or execute
command.
7. When the parameter setting is completed, LCD display will show the end code "-END-" and
automatically return back to parameter mode.
Revision April 2009
Call 1(800)985-6929 for Sales

Keypad Operation

Para mete r Mod e
MODE
Monitor
Param eter
deltaacdrives.com
Chapter 4 Display and Operation|ASDA-A&A+ Series
S HIFT
S HIFT S HIFT
Basic Extension
Param eter Parameter
deltaacdrives.com
sales@deltaacdrives.com
S HIFT S HIFT
Co mm unication Diagnosis
Parameter Parameter
to display setting value
SET
or
to save setting value
SET
Para mete r Setting Mode
sales@deltaacdrives.com
or
4-3