Delta Electronics ASDA-A Series User Manual page 150

Call 1(800)985-6929 for Sales
The timing chart of speed / position control mode selection is shown as the figure below:
In position mode (when T-P is ON), the motor will start to count pulse and operate following the external
pulse command. When switching to the torque mode (when T-P is OFF), it will stop counting pulse even
if the pulse command is continuously sent out. The torque command is determined by TCM0~1 and the
motor will rotate following the command. After T-P is ON again, it will immediately return to position
mode.
For the relationship between DI signal and selected command in each mode, please refer to the
introduction of single mode.
Revision April 2009
Call 1(800)985-6929 for Sales
deltaacdrives.com
Chapter 6 Control Modes of Operation|ASDA-A&A+ Series
deltaacdrives.com
sales@deltaacdrives.com
6-37
sales@deltaacdrives.com