Configuring The Modem At The Srx550 High Memory Services Gateway End; Table 50: Port Settings - Juniper SRX550 Hardware Manual

Related
Documentation

Configuring the Modem at the SRX550 High Memory Services Gateway End

Copyright © 2016, Juniper Networks, Inc.
Chapter 16: Connecting the SRX550 High Memory Services Gateway to External Devices

Table 50: Port Settings

Port Settings
Bits per second
Data bits
Parity
Stop bits
Flow control
In the HyperTerminal window, type
5.
For more information on the AT commands, see the
.
for Security Devices
An response indicates that the modem can communicate successfully with the
OK
COM port on the management device.
To dial the modem that is connected to the console port on the services gateway,
6.
type
ATDT remote-modem-number
connected to the console port on the services gateway is
.
0019785551234
The services gateway login prompt appears.
Log in as the user root . No password is required at initial connection, but you must
7.
assign a root password before you commit any configuration settings.
Connecting to the SRX550 High Memory Services Gateway from the CLI Remotely on
page 133
Configuring the Modem at the SRX550 High Memory Services Gateway End on page 113
Connecting the Modem to the Console Port on the SRX550 High Memory Services
Gateway on page 110
Before you can connect a dial-up modem to the console port on the SRX550 High Memory
Services Gateway, you must configure the modem to accept a call on the first ring and
to accept DTR signals. You must also disable flow control on the modem.
NOTE: These instructions use Hayes-compatible modem commands to
configure the modem. If your modem is not Hayes-compatible, refer to the
documentation for your modem and enter equivalent modem commands.
Value
9600
8
None
1
None
.
AT
Installation and Upgrade Guide
. For example, if the phone number of the modem
0019785551234 , type ATDT
113