Removing Power Supply Units; Unpacking And Checking Package Contents - Avaya G450 Manual

Removing power supply units

About this task
For ease of installation and to enable single-person installation, it is recommended to remove the
power supply unit(s) before unpacking the Branch Gateway.
Procedure
1. Open the package.
2. Turn the Branch Gateway, so that the rear panel is facing up.
3. Remove the power supply unit (PSU).
If you ordered two PSUs, remove them both.
a. Loosen the two PSU captive screws, one on each side of the PSU.
b. Grasp the two side handles and pull the PSU up and out.
c. Place the PSU carefully on the table.

Unpacking and checking package contents

About this task
For the Branch Gateway package:
Procedure
1. Unpack the Branch Gateway and accessories.
Electrostatic alert:
Wear an anti-static wrist ground strap whenever handling components of a Branch
Gateway. Connect the strap to an approved ground, such as an unpainted metal
surface.
2. Check the contents of the packaging against the customer order.
3. Cross-check the customer order with the planning documentation you have been given.
Media modules, telephones and other equipment are listed on your planning and shipping
documentation. Placement for the media modules and other equipment are also indicated.
4. Verify that all necessary elements have been received and are in good condition.
If there are missing or damaged elements, contact your project manager. The planning
documentation will list contact information for key personnel.
Result
If you have any questions about the equipment order, or if the equipment has been damaged,
contact your project manager.
October 2019 Deploying and Upgrading Avaya G450 Branch Gateway
Comments on this document? infodev@avaya.com
Branch Gateway package contents
21