Removing And Installing The High Pressure Pump - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
6.2 Removing and installing the high pres‐
sure pump
Removing
• Engine cold.
WARNING
Risk of injury caused by fuel which is under high pressure.
♦ Before opening the high-pressure system, the fuel pres‐
sure must be reduced to residual pressure
⇒ "3.10 Reduce pressure in the high-pressure system",
page 10 .
Caution
Risk of malfunctions caused by soiling.
♦ ⇒ "3.1 Rules of cleanliness", page 7
– Remove high pressure pipe
⇒ "6.3 Removing and installing high pressure pipe",
page 263 .
– Separate electrical plug connection -1-.
Note
Place a cloth below to absorb leaking fuel.
– Loosen hose clamp -2- and remove fuel intake hose.
– Unscrew screws -3- and remove high pressure pump with roll‐
er tappet.
Install
– Inspect roller tappet for damage, if necessary replace.
– Moisten roller tappet -1- with clean engine oil.
262
Rep. gr.24 - Mixture preparation - injection