Removing And Installing Charge Pressure Sender Gx26 - Skoda Octavia III 2013 Workshop Manual

11 - Intake manifold pressure sender - GX9-
❑ comprises:
Intake air temperature sender 2 - G299-
Intake manifold pressure sender - G71-
❑ installing and removing
⇒ "5.1 Removing and installing intake manifold pressure sender GX9 ", page 257
12 - Charge pressure sender - GX26-
❑ comprises:
Charge pressure sender - G31-
Intake air temperature transmitter - G42-
❑ installing and removing
13 - O-ring
❑ replace after removal
14 - Air guide pipe
15 - Inlet connections
16 - O-ring
❑ replace after removal
17 - O-ring
❑ replace after removal
18 - Bolt
❑ thread forming
❑ position and screw in by to allow the screw to find the old thread. Next, tighten screw to the given tight‐
ening torque.
❑ 7 Nm
19 - Retaining clip
❑ For air guide pipe
20 - Throttle valve module - GX3-
❑ comprises:
Throttle valve module - J338-
Throttle valve drive - G186-
Throttle valve drive angle sender 1 - G187-
Throttle valve drive angle sender 2 - G188-
❑ installing and removing
21 - Sealing ring
❑ replace after removal
22 - Gasket
❑ 4 pieces
❑ replace after removal
2.2 Removing and installing charge pres‐
sure sender - GX26-
The charge pressure sender - GX26- consists:
♦ Charge pressure sender - G31-
⇒ "2.2 Removing and installing charge pressure sender GX26 ", page 229
⇒ "3.3 Removing and installing the throttle valve control unit GX3 ", page 244
Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
229
2. Charge-air system