Skoda Octavia III 2013 Workshop Manual page 108

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
– Unscrew screws -A...D- and push thermostat cover -1- to the
side.
Position crankshaft to "TDC"
– Remove ignition coil with power output stage 1
– Remove ignition plug cylinder 1 with spark plug socket
wrench , e. g. -3122 B- .
Set the correct position of the crankshaft for screwing in the fixing
screw.
– Carefully insert a screwdriver into the opening of the ignition
plug, minimum length of shaft 250 mm, in -direction of arrow-
so that it touches the piston head.
– Rotate the crankshaft in direction of rotation of engine on
"TDC" for cylinder 1.
– Turn engine shaft further in direction of arrow so that the
screwdriver just out at the top by approx. 35 mm in the
-direction of the arrow-.
– Unscrew locking screw for "TDC" bore at the cylinder block
⇒ page 81 .
Caution
Risk of engine damage.
If the fixing screw - T10340- cannot be screwed in up to the
stop, the crankshaft is not in the correct position.
In this case, proceed as follows:
♦ Unscrew the fixing screw.
♦ Set the correct position of the crankshaft for screwing in
the fixing screw ⇒ page 102
102
Rep. gr.15 - Cylinder head, valve gear
⇒ page 282
.
.