Skoda Octavia III 2013 Workshop Manual page 203

– Unscrew the cap -1- for the fuel filler neck.
Note
Close the opening of the fuel filler neck with a clean cloth so that
no dirt can penetrate.
– Removing the rear right wheel.
– Remove the rear right wheelhouse liner ⇒ Body Work; Rep.
gr. 66 .
– Remove the rear wheel brake calliper and store to on side ⇒
Suspension; Rep. gr. 46 .
– Disconnect the plug connection from the ABS speed sensor,
right rear wheel, and undo the line from the mounting brackets
at the rear axle ⇒ Suspension; Rep. gr. 45 .
– Remove the vent lines -1- and -2- from the activated charcoal
filter, do so by disconnecting the push-fit couplings
⇒ "2 Separating push-on couplings", page 211
– Loosen ventilation lines from fasteners on the holder
-arrows-.
– Loosen ventilation line -1- from fastener on the holder
-arrow-.
– Disconnect the exhaust pipe with body saw , e. g. -V.A.G 1523
A - or grinder, and remove the middle- and rear part of the
exhaust system separately
⇒ "1.4 Removing and installing or replacing the middle and
rear silencer", page 277
– Unscrew screws -1- -2- for fuel filler neck.
WARNING
Risk of injury caused by fuel which is under high pressure.
To relieve the pressure in the fuel system, place a clean cloth
around the connection point and carefully loosen the connec‐
tion point.
– Unclip hand-brake cables from the holders.
.
.
Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
1. Fuel tank and fuel delivery unit
197