– Undo screws -1-, -2- by around one turn, to do so use the
counterholder - T10172- with adapters -T10172/2- and -
T10172/1- .
– Release screw -1- using insertion tool - T10500- .
– Slacken the tensioning pulley at the eccentric -2- using the
wrench - T10499- .
Caution
There is a risk of destruction through reversing the rotation di‐
rection of an already used toothed belt.
♦ Mark the direction of rotation with chalk or a felt-tip pen for
the re-installation before removing the toothed belt pulley.
– Remove timing belt.
– Remove crankshaft toothed belt pulley -1- -arrow-.
Installing (set the timing)
Note
♦
Replace screws which have been tightened firmly to a torque
angle.
Renew O-ring of locking screw if damaged.
♦
– "Check TDC" position of camshaft and crankshaft:
•
Camshaft clamp - T10494- attached to camshaft housing.
Caution
Risk of damaging the camshafts.
♦ Do not use the camshaft clamp -T10494- as a counter‐
holder.
Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
105
2. Toothed belt drive