Note
The sealing flange -1- is pressed together with the sensor rotor
-2- from the crankshaft -3-.
– To press out, insert 3 screws M6x35 -arrows- into the sealing
flange -1- alternately by a maximum of
– Remove sealing flange -1- with sensor rotor -2-.
Press in sealing flange with rotor
Note
The sealing flange with a PTFE seal is equipped with a sealing
♦
lip support ring. This support ring serves as a fitting sleeve and
must not be removed prior to installation.
Sealing flange and sender wheel must not be separated or
♦
turned after removal from packaging.
The rotor is held in its installation position on the assembly
♦
device - T10134- by a locating pin.
Sealing flange and oil seal form one unit and must only be
♦
renewed together with the sender wheel.
The assembly device - T10134- is held in its position relative
♦
to the crankshaft by a guide pin, which is inserted into a hole
in the crankshaft.
Assembly of the assembly device - T10134- :
A - Clamping surface
B - Nut
C - Assembly housing
D - Locating pin
E - Allan screws (2 pieces)
F - Guide bolts (for petrol engines)
G - Guide bolts (for diesel engines)
H - Knurled screws (3 pieces)
I - Inner part
A - Assemble sealing flange with rotor on the assembly device -
T10134- :
– Untwist nut -B- until just before it touches the clamping surface
-A- of the threaded spindle.
Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
1
/ 2 turns each.
2. Cylinder block, gearbox end
51