High Pressure Pump; Summary Of Components - High Pressure Pump - Skoda Octavia III 2013 Workshop Manual

6

High pressure pump

⇒ "6.1 Summary of components - high pressure pump",
page 261
⇒ "6.2 Removing and installing the high pressure pump",
page 262
⇒ "6.3 Removing and installing high pressure pipe", page 263
6.1

Summary of components - high pressure pump

1 - Roller tappet
❑ Moisten with engine oil
during installation
2 - O-ring
❑ replace after removal
❑ Moisten with engine oil
during installation
3 - High pressure pump
❑ with fuel dosage valve -
N290-
❑ do not disassemble
❑ installing and removing
⇒ "6.2 Removing and in‐
stalling the high pres‐
sure pump", page 262
4 - High pressure tube
WARNING
Risk of injury caused by
fuel which is under high
pressure.
♦ Before opening the high-
pressure system, the fuel
pressure must be re‐
duced to residual pres‐
sure
⇒ "3.10 Reduce pressure
in the high-pressure sys‐
tem", page 10 .
❑ installing and removing
⇒ "6.3 Removing and in‐
stalling high pressure
pipe", page 263
❑ replace if damaged
❑ Connections must not be damaged
❑ Moisten thread of the union nuts with clean engine oil
❑ 25 Nm
5 - Bolt
❑ replace after removal
❑ Tightening torque and tightening order
6 - Hose clamp
7 - Fuel feed line
8 - Electrical plug connection
Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
⇒ page 263
261
6. High pressure pump