Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
– Fit torque wrench, e. g. - VAS 6583- with hexagon socket
SW10 insert -Pos. 6- to the coolant pump.
– Preload coolant pump with a 10 mm hexagon socket insert
-6- with extension and torque wrench e.g. - VAS 6583- to
30 Nm clockwise.
– Position the torque wrench - VAS 6583- vertically for better
handling.
Note
Do not support torque wrench with the other hand.
♦
In order to avoid the belt tension being too high the torque
♦
wrench must not be »put under excessive pressure«.
– Keep coolant pump pretensioned.
– At the same time, have a second mechanic pre-tighten the
fixing screws on the coolant pump clockwise in sequence from
right to left, beginning with screw -2-, -1- and -5- »3. Pretighten
stage« to 10 Nm.
– Then tighten the fixing screws to the »4th. stage«.
Stage
Bolts
3rd
-2-, -1-, -5-
4th
-3-, -4-, -5-, -1-,
-2-
Continued installation is carried out in the reverse order. When
installing, note the following:
– Replenish coolant
⇒ page 151
Tightening torques
♦
⇒ "1.1.2 Summary of components 2- exhaust gas turbocharger
", page 222
♦
⇒ "2.1 Summary of components - coolant pump/coolant ther‐
mostat", page 154
♦ Battery tray ⇒ Electrical system; Rep. gr. 27
2.5
Removing and installing toothed belt
pulley for coolant pump
Special tools and workshop equipment required
♦ Counterholder - T10172- with adapters -T10172/2-
Removing
– Remove coolant pump
⇒ "2.4 Removing and installing coolant pump", page 158
162
Rep. gr.19 - Cooling
Tightening torque
10 Nm
12 Nm
.
.