Removing And Installing Coolant Temperature Sender At Radiator Outlet G83 - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
– Briefly open the cap -arrow- for the coolant expansion reser‐
voir in order to remove the remaining pressure in the coolant
system, then close until it clicks into place.
– Disconnect plug connection from the coolant temperature
sender - G62- .
Note
Place a cloth below to catch any leaking coolant.
– Undo screw -1- and remove coolant temperature sender -
G62- Pos. -2-.
Note
If the O-ring -3- with support ring -4- remains in the cylinder
♦
head, lift out the O-ring with support ring using a wire.
Insert new coolant temperature sender - G62- immediately in‐
♦
to cylinder head in order to avoid loss of coolant.
Install
Installation is carried out in the reverse order. When installing,
observe the following:
Note
Renew O-ring.
– Check coolant level ⇒ page 151
Tightening torque
Component
Screw of sender
2.9 Removing and installing coolant temper‐
ature sender at radiator outlet - G83-
Removing
• Engine cold.
– Briefly open the cap -arrow- for the coolant expansion reser‐
voir in order to remove the remaining pressure in the coolant
system, then close until it clicks into place.
– Remove the sound dampening system ⇒ Body Work; Rep.
gr. 66 .
168
Rep. gr.19 - Cooling
.
Nm
8 Nm