Skoda Octavia III 2013 Workshop Manual page 81

– Remove connector -arrow- from manifold pressure sender -
GX9- .
– Disconnect electrical plug connections:
2 - For valve 1 for camshaft control - N205- .
4 - For Hall sender - G40- .
– Unscrew screw -3- and expose the wiring loom and lay it to
the left-hand side.
– Pull out oil dipstick -1-.
– Loosen the screws for the camshaft housing in the sequence
-15...1- and unscrew them.
– Carefully unscrew the camshaft housing and remove from the
bonding.
– When installing again, mark the assignment of the roller rocker
finger and the balancing elements.
– Remove the roller rocker finger together with the balancing
elements and lay aside on a clean surface.
Install
Note
♦ Replace screws which have been tightened firmly to a torque
angle.
Replace gasket with oil strainer.
♦
– "Check TDC" position of camshaft and crankshaft:
• Attach camshaft clamp -T10494- to camshaft housing using
screw -arrow-.
Caution
Risk of damaging the valve gear.
♦ When turning, the camshafts must not be moved axially.
Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
75
1. Cylinder head