– Unscrew respective lambda probe using a spanner from the
lambda probe ring spanner set - 3337- .
1 -
Lambda probe 1 after catalytic converter - GX7-
2 -
Lambda probe 1 in front of the catalytic converter - GX10-
Install
Installation is carried out in the reverse order. When installing,
observe the following:
Note
New lambda probes are coated with assembly paste. This
♦
paste must not come into contact with the slots of the lambda
probe body.
For a re-used lambda probe, only coat the thread with hot bolt
♦
paste. This paste must not come into contact with the slots of
the lambda probe body. Hot bolt paste ⇒ Electronic Catalogue
of Original Parts"ETKA"
The electrical cable wire connection of the lambda probe must
♦
be secured again at the same points during installation. Con‐
tact between the electrical cable connection and the exhaust
pipe must be prevented.
Tightening torque
Component
Lambda probe 1 after catalytic converter - GX7-
Lambda probe 1 in front of the catalytic convert‐
er - GX10-
Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
Nm
55 Nm
55 Nm
267
7. Lambda probe