Programming The Ipsi For Dhcp Addressing - Avaya S8700 Series Installing And Configuring

Hide thumbs Also See for S8700 Series:

Table of Contents

Programming the IPSI for DHCP addressing

Important:

If an IPSI is in a port network that is backed up with the Enterprise Survivable

Important:

Server (ESS) option you must use static addressing for the ESS to provide

service to the port network.

For the TN2312BP IPSI circuit packs to receive IP addresses dynamically, you first must assign

the switch ID and cabinet number to each IPSI circuit pack.The switch ID is a single letter, A

through J. The cabinet number is a 2-digit number, 01 through 64. For G650 Media Gateways, a

cabinet is defined as one or more media gateways connected by a TDM cable. This cabinet

configuration is called a G650-rack-mount-stack.

Note:

In the following procedure, you must start step 2 within 5 seconds after inserting

Note:

the circuit pack.

1. Fully insert the TN2312BP IPSI circuit pack. If necessary, reseat the circuit pack to start

the programming sequence.

Note:

For the following step, do not use a graphite pencil.

Note:

2. Insert a pen, golf tee, or similar object into the recessed push button switch.

Installing and Configuring the Avaya S8700-Series Media Server

CLK

Setting the VLAN and diffserv parameters

February 2007

Table of Contents