Note:
This step is important because any other values in these fields cause the
Note:
following steps to fail.
3. Connect to the services port on the IPSI circuit pack.
4. Log in to the IPSI circuit pack as craft.
5. Type set control interface ipaddr netmask and press Enter.
6. If required, set the gateway IP address (set control gateway gatewayIPaddr,
where gatewayIPaddr is the customer-provided IP address for the gateway).
7. Type exit to exit the session. Do not reset the IPSI circuit pack at this time.
Note:
If you reset the IPSI, this procedure will not work, and the IP address of the IPSI
Note:
will display as 0.0.0.0.
8. Watch the display on the IPSI circuit pack faceplate: it should change from A00 to IP.
9. If necessary to set V-LAN properties, Priority, Tag, ID, etc., log back into the IPSI to set
these parameters.
Assigning DHCP addressing
To assign DHCP addressing to the replacement IPSI circuit pack:
1. Plug the circuit pack into the appropriate slot in the media gateway or if already plugged in,
reseat it (unplug and replug).
2. While "IP" flashes on the display, push the recessed button on the IPSI faceplate and hold
for 5 seconds.
The display changes to A00 with the first character (A) flashing.
3. Push the recessed button to program the server ID and cabinet number for DHCP
addressing.
Assigning DHCP addressing
03-300529 Issue 4 January 2008
165