SATO SG112-ex Operator's Manual page 50

3 Loading the Ribbon and Media
4
Feed the media (print side face up) with
both hands into the media inlet  located
at the back of the product.
When media is inserted, it feeds media with
automatic paper feed function.
Note
• Place the media so that the media is straight as shown
in the picture.
• Make sure that there is no obstruction on the rear of
the product, providing a smooth flow of the media.
• The automatic paper feed function corresponds to
media with thickness of 0.12 mm (0.005") or more.
When using media less than 0.12 mm (0.005"), load
the media manually. Open the top cover and unlock
the print head assembly, insert the media from the
media inlet, then pass the media between the print
head and the platen roller, and close the print head
assembly.
• The maximum stacking height of the fan-fold media
is 100 mm (3.9") from the surface on which the
product rests.
CAUTION
When closing the top cover or the print head
assembly, be careful not to pinch your fingers.
5
After completing the media feed, press
the LINE button to bring it online.
6
After loading the media and ribbon,
perform a test print to make sure that the
media is loaded correctly.
Refer to the Section 4.2.11 Test Print Mode
details on how to perform a test print.
48
SG112-ex Operator Manual
3
for
LINE