SATO SG112-ex Operator's Manual page 239

Note
• You can set the external signal type (TYPE1 to TYPE4) for PREND output signal of pin No. 6. Refer to the
EXTERNAL SIGNAL screen of the
• The Print Done/Print end signal of pin No. 6 is not output when "0" is specified in the number of cuts in the
command specifying the number of cuts during the cutting operation.
Input/output circuit diagram of 14-pin external signal interface (Amphenol 14 pins,
female connector)
Advanced Mode
14 pin type
An example of input/ output connection
Peripheral
device
5~40V
FG case ground
menu for details.
13 +5V
JP7(Select input power supply)
Input
Output
SG ground
8 Appendix
SG112-ex Operator Manual
237