SATO SG112-ex Operator's Manual page 72

4 Operation and Configuration
OFFSET VOLUME
The setting values of the adjustment mode are shown.
• PITCH: Shows the print position offset value.
• OFFSET: Shows the stop position offset value.
• DARKNESS: Shows the darkness setting value.
You can change these values in
PRINT SPEED
Adjusts the print speed.
The setting range is from 03 IPS to 06 IPS (inches/sec).
Note
Setting the print speed to a level that is too fast may affect the print quality.
PRINT DARKNESS
Specify the print darkness from ten steps.
The setting range is from 1 to 10. 1 is the lightest and 10 is the darkest.
PITCH OFFSET
This setting adjusts the pitch offset value.
The media pitch is the distance between the leading edge (the edge that
comes out of the product first) of the media and the leading edge of the
next media. Once the position has been set, it can be fine adjusted using
the PITCH POSITION in adjustment mode.
The setting range is from -49 mm (-1.9") to +49 mm (+1.9") and is
adjustable by 1 mm (0.04") steps.
Set the offset value with '+' to move the print position opposite the feed
direction and value with '-' to move the print position in the feed direction.
70
SG112-ex Operator Manual
Adjustment Mode and Test Print Mode.