SATO SG112-ex Operator's Manual page 175

Error
No. Message
Overheat error
26
Command error
27
Note
This screen shows
only when
COMMAND
ERROR in
ADVANCED
MODE is set to
ENABLE.
CRC check error
35
LED/Buzzer
ONLINE: Flashes The temperature of the
green product has exceeded its
STATUS: Flashes tolerance value.
red.
LABEL: Off
RIBBON: Off
One long beep.
To clear the error:
Stop the operation of
the product and wait
until the temperature
decreases.
ONLINE: Off Incorrect command or
STATUS: Lights red. parameter in the print
LABEL: Off data.
RIBBON: Off For details of the error,
check the "Caaa: <bb>:
Three short beeps. cc" part at the bottom of
the screen.
To clear the error: Caaa: position of error
Press the LINE occurrence
button.
<bb>: error command
name
cc: error code
ONLINE: Flashes The CRC code of the data
green to be sent (one item) is
STATUS: Flashes incorrect.
red.
LABEL: Off
RIBBON: Off
Three short beeps.
To clear the error:
Press the LINE
button or cancel the
print job.
Cause Countermeasure
Stop the operation of the
product to let the
temperature decrease.
Check the print data.
Refer to
More Information about
Command Error
details.
Check the data to be sent
and the communication
settings.
LINE button: Continue
printing from the print data
where the CRC error
occurred.
Send the SUB command:
Clear the CRC error and
continue printing from
where it stopped.
SG112-ex Operator Manual
7 Troubleshooting
Section 7.1.1
for
173