SATO SG112-ex Operator's Manual page 167

4
Lift up the print head assembly  to the
maximum.
CAUTION
• The print head and its surroundings are hot after
printing. Be careful not to touch it, to avoid being
burned.
• Touching the edge of the print head with your bare
hand could cause injury.
5
Remove the media, carbon ribbon and
make the print head visible.
6
Place the cleaning sheet  between the
print head and the platen roller .
Note
• The matte side of the cleaning sheet should be
facing upwards (print head).
7
Insert the cleaning sheet from the back
of the front panel and the leading edge
out from the media discharge outlet .
Make sure that there is enough area for you to
pull the cleaning sheeting and area for the
cleaning sheet to cleaning the print head.
8
Close the print head assembly . Press
on both sides as shown by the arrow to
close it tightly until it clicks.
3
Matte side
5
3
SG112-ex Operator Manual
6 Maintenance
4
6
165