SATO SG112-ex Operator's Manual page 165

After cleaning
1
Place the media lid  back to its original
position.
Attach the two side of the media lid to the nip
roller shaft. And then press on the two corner of
the media lid until it snaps to position.
2
Load the carbon ribbon back to the
product.
3
Close the print head assembly .
Press on both sides as shown by the
arrow to close it tightly until it clicks.
4
Close the top cover.
CAUTION
When closing the top cover, be careful not to pinch
your fingers.
3
SG112-ex Operator Manual
6 Maintenance
7
163